Clone 3D Router Duplicator
EXTRAS


clone 3d gun stock duplicator

The rotating clamping system enables 360 degree carving.

The rotating clamp system comes in two parts. Unit One has two adjustable stainless steel centres. Unit Two houses the workings which enable the master and blank to rotate in unison. Having the workings inside the aluminium housing keeps the components free from dust.

The main shafts on Unit Two can be locked to prevent them from turning when carving. The aluminium faceplates are removable and have plenty of screw fixing holes. Both Units have 6 height positions.

Prices:

Rotating clamping system for Clone 3D CD300. £995

Rotating clamping system for Clone 3D CD400. £1045
Xact Router Motor


• High torque motor that won't slow down under load
• Variable speed control from 10,000 to 20,000rpm
• Massive 2400 watt motor with 'sealed for life' bearings
• Perfect for routing hard and softwoods with large or small diameter cutters
• Quiet running and virtually vibration free routing

The Clone 3D can now accommodate the large Xact router motor. These motors can be purchase in the UK from Amazon.co.uk by following this link.

 

Bosch 1617EVS 2-1/4 HP Variable-Speed Router - US & Canada Only


The Bosch 1617EVS router is recommended for US and Canadian residents. They can be purchase from Amazon here.

 

4 Piece Round Nose Router Bit Set

For general carving, this 4 piece round nose router bit set is a good choice. They are the same bits that are used in all of the Clone 4D demo videos. For UK residents they can be purchased from Amazon here. For US residents very simliar bits can be purchase here.

 


Additional stylus tips are made to order to customers requirements.

£20 each for nylon tips

£25 each for steel tips (steel is used on small diameters for added strength)

All tips come attached to a machined stainless steel round bar.

Ordering additional stylus tips.

When ordering additional stylus tips please send dimensions of the cutter you would like the stylus tip pairing with and specify whether you require the tip to be 'like for like', +1mm diameter, +2mm diameter etc.

Round nose or flat bottom cutters?

Round nose stylus tips move over the master easier, and the cutters tend not to lift the wood when cutting quite as much as flat bottom cutters. 'Like for like' flat bottom cutters are recommended when carving cut outs, channels etc.

 

 

Copyright www.cloneduplicators.uk